Sector Mesh Coils Horizontech

Out-of-Stock

You don't smoke? Do not vape!

Sector Mesh Coils Horizontech

The Sector Mesh Resistances from Horizon Tech are replacement parts specially designed for the innovative Falcon 2 clearomizer. Thanks to the use of a mesh-based resistive material, they generate abundant and dense vapor.

These resistances, offering an optimal power ranging between 70 and 75 watts, ensure an unmatched vaping experience. The resistive comes in the form of a conical mesh, and has a value of 0.14 Ohm.

Pack of 3 Sector Mesh Resistances in 0.14 ohm from Horizontechfor Falcon II.

Usage range: Between 70W and 75W.

The Sector Mesh Resistances from Horizon Tech for the Falcon 2 are made from a mesh resistive material, to provide thick vapor and intense flavors. The cone-shaped mesh enhances the performance of these resistances.

The 0.14 ohm mesh resistance is specifically intended for direct inhalation, ideally performing at a power of 70 to 75 watts.

Several indicators allow to recognize a resistance reaching the end of its cycle:

Decrease in flavors
Reduction in vapor production
Occasional perception of a burnt taste
Soiling of the cotton and the resistance

To replace the Falcon 2 resistance, follow these instructions:

Unscrew the base of your Falcon 2.
Extract the resistance by pulling gently.
Soak your new resistance by adding 7 to 8 drops of e-liquid on the cotton.
Put the resistance back in place and screw the base back on.
Start vaping at reduced power for the first few puffs.

To properly prime your resistance and avoid any premature combustion, here is the procedure to follow:

Drop 6 to 7 drops of e-liquid in the center of the resistance to saturate the cotton in direct contact with the resistive wire.
Apply 1 to 2 drops of e-liquid on the cotton visible through each side opening of the resistance.