GT4 Resistors

Designed in Kanthal and specifically developed for the Vaporesso NRG and NRG SE clearomizers, the 0.15 ohm GT4 Mesh resistors are ready to take you to new vaping heights!

Operating on a power range of 30 to 70W, the GT4 Mesh coils ensure a quick and even temperature rise for ideal vaporization of your e-liquid.

Abundant vapor clouds and intense flavors await you!

To ensure an optimal and consistent vaping experience with your kit, it is crucial to change the resistor when it shows signs of wear or to prevent rapid clogging due to frequent e-liquid changes.

Here are some simple indicators to recognize the wear state of your resistor and the need to replace it:

• A less dense and less voluminous vapor;
• An increasingly acrid taste, a dry throat feeling and even the appearance of dry hit (burnt taste in mouth).

When you want to switch from one resistor to another or replace your used coil following intense vaping sessions, follow these steps:

1. Unscrew the base of your NRG or NRG SE clearomizer to access the resistor;
2. Remove the old resistor and install the new one in its place;
3. Moisten the new cotton by applying your e-liquid on the openings around the resistor, to prime it and prevent it from burning during its first use;
4. Reassemble your entire clearomizer by gently screwing each element.

After replacing the resistor, fill the tank to ¾ and wait about ten minutes before starting to vape again, so that the new resistor is impregnated with e-liquid.