TA Coils SMOK

Out-of-Stock

You don't smoke? Do not vape!

TA Coils SMOK

5 pieces

Explore the world of vape with a twist thanks to Smok's e-cigarette and clearomizer resistors. These TA resistors, sold in packs of 5, redefine your vaping experience by allowing you to customize your vape according to your preferences.

Ideal for a direct vaping experience.
Offered in an impedance value of 0.2 ohm.
Compatible with the T-Air clearomizer.
Resistors specially designed for optimal flavor rendering.
Ideal for a Subohm vaping experience.

Pack of 5 TA resistors from Smok.

To be used between 50 and 70 watts in direct inhalation.

Enjoy an exceptional vaping experience thanks to the innovative and high-performance resistors from Smok. These TA resistors promise to transcend your vape with a perfect restoration of flavors and voluminous clouds of vapor, once again demonstrating the brand's incomparable expertise.

The compatibility of TA resistors:

These TA resistors are specifically designed for the T-Air Subtank clearomizer, thus eliminating confusion among a multitude of resistor references. Your choice is therefore simplified!

Subohm Vaping:

The Smok TA resistors are a boon for cloud chasing enthusiasts! The brand has considered vapers who prefer generous vapor vaping, by offering resistors suitable for predominantly VG e-liquids. Expect a dense experience in vapor clouds and subtle flavors.

Value of resistors:

0.2 ohm TA resistor: to be used in a power range between 50 and 70 watts.

When should you change the Smok TA T-Air resistor?

It is essential to know when to replace the TA T-Air mesh resistor of your Mag Solo kit and its DL T-Air Subtank clearomizer.

Here are some signs that it's time to do it:

Significant decrease in the quality of the vapor, which becomes less dense and less rich in flavors;
An increasingly harsh taste when inhaling, with sensations of dryness in the throat or even the appearance of a dry hit (burned taste).

How to install a TA T-Air Smok resistor in the Mag Solo kit?

Replacing the Smok TA T-Air resistors is a breeze thanks to their plug & play system without threading.

Keying prevents incorrect installation:

Remove the T-Air Subtank clearomizer from your Smok Mag Solo kit.
Unscrew the base of the Smok clearomizer.
Extricate the Smok TA T-Air resistor from the tank with your nails.
Prime the new Smok TA T-Air resistor by dropping a few drops of e-liquid on its vents.
Insert the new resistor at the bottom of the tank following the keying.
Screw the base of the clearomizer onto your Smok Mag Solo DL kit and mount it on your Smok Mag Solo box.
Wait about ten minutes before vaping to allow the new resistor to soak up the e-liquid.

Data sheet